STARTEX Primer

STARTEX Primer is a pigmented penetrating primer, which is absorbed deeply into the substrate of cementitious materials, plasters and limes. It binds the substrate and the surface, to give a solid base for decorative finishing coats, such as SAMHWA Textured Coatings, paints and thin-layer mortars.st interior building surfaces.

For exterior and interior use on sand/cement render, cast-in-situ and precast concrete, lightweight concrete. Is especially suitable for sealing old, dry, absorbent, untreated concrete. On all high-alkali surfaces such as concrete, blockwork, and cement renderings it is recommended that SAMHWA STARTEX Primer be used prior to the application of SAMHWA Coating Systems.

View more

Procedure

1. Surface Preparation

All surfaces must be free of dust, sand, soil, and oil.
When repairing, all previously painted residues must be removed.

2. Environmental Condition

Air temperature: 5 ~ 35 °C
Relative humidity: up to 80%
The surface temperature must be at least 5°C above the dew point to prevent moisture condensation

3. Application Equipment

Brush, roller, spray

Caution for usage

1. Mixed paints should be used within pot life

2. Do not mix with other paints

3. Avoid applying paint on rainy days, high humidity(over 80%), low temperature (below 5°C), and high temperature (over 40°C surface temperature)(Coating film crack, adhesion failure, bubble generation may occur)

4. When applying over a pre-coated surface, refer to the manufacturer's Application System for instruction.

5. Please use this product within the validity period because it may be deteriorated since this product is a chemical product.

Caution for handling

1. Do not use any other purpose

2. Protect from freezing

3. Keep out of reach of infants and children. Do not apply to infants, children's equipment or food storage containers.

4. Avoid access to direct sunlight and fire when transporting, storing and handling, and store in a dry, cold place at room temperature(5~35°C)

5. Please keep this product container sealed so that the injection port faces upward.

6. Be careful that the paint does not come into contact with eyes and skin.

7. If paint comes in contact with eyes and skin, wash thoroughly with running water and seek medical attention

8. If inhaled or ingested, please seek medical advice immediately and follow the medical advice given in the container

9. Avoid work in a confined space, and if you unintentionally paint, ventilate it thoroughly with exhaust system before

10. The best way to preserve paint is to store it in an airtight container to keep the water from evaporating and prevent microorganisms from getting in

11. Dispose of the waste paint through the waste disposal company designated by the Ministry of Environment

12. For other inquiries, please contact our Customer Service Center or refer to the Material Safety Data Sheet(GHS-MSDS),
Technical Data.

Warning

Please consult our enclosed here with warning notice

Packing & Storage

Store containers in a clean dry area protected from direct sunlight and extreme heat and cold.

Unopened containers can be stored for 12 months. Use oldest material first.

View more

Product	IPremium quality matt emulsion paint	RecommendedThickness	30~50μm
Specific Gravity	1.08	Consumption	6.33m2/L (DFT 30μm, Depends on the substrate’s porosity)
Coats	1~2	Packing Unit	18L containers
Volume Solid (%)	19±3	Shelf Life	24 months (in original unopened containers)

View more

Other Products

WORLDTEX Interior picture_as_pdf

WORLDTEX Interior is an economical interior grade matt emulsion, suitable for use on most interior building surfaces.

EASYTEX Exterior picture_as_pdf

EASYTEX Exterior is a high-quality, weather-resistant acrylic paint, suitable for use without a primer on exterior and interior surfaces of concrete, plywood, anti-rust primed steel, etc. EASYTEX Exterior gives outstanding economy with the advantage of a low material consumption rate and excellent adhesion. Application is by brush, roller airless or conventional spray. Various colours can be matched on request.

EASYTEX Interior picture_as_pdf

EASYTEX Interior is an economical interior grade low reflectance matt emulsion suitable for use on ceilings. EASYTEX Interior can be applied as an even coating or in stippled form. It is normally available in white but special shades can be made to order.

EASYTEX Primer picture_as_pdf

EASYTEX Primer is a highly developed product in liquid form, which is absorbed deeply into the substrate of cementitious materials, plasters and limes. It binds the substrate and the surface, to give a solid base for decorative finishing coats, such as SAMHWA Textured Coatings, paints and thin-layer mortars. EASYTEX Primer is available in clear.

STARTEX Exterior picture_as_pdf

STARTEX Interior is a high quality matt emulsion with high coverage suitable for application on most internal building surfaces. It offers the advantage of low material consumption with a high quality professional finish.

STARTEX Interior picture_as_pdf

WORLDTEX Exterior picture_as_pdf

WORLDTEX Interior is an economical interior grade matt emulsion, suitable for use on most interior building surfaces.

WORLDTEX Primer picture_as_pdf

WORLDTEX Primer is a highly developed product in liquid form, which is absorbed deeply into the substrate of cementitious materials, plasters and limes. It binds the substrate and the surface, to give a solid base for decorative finishing coats, paints and thin-layer mortars. It is supplied as white or tinted as per finish colour.